Oki MC860 Maintenance Manual page 111

Oki Data CONFIDENTIAL
Item
Network IPv6 Address (local) xxxx:xxxx:
xxxx:xxxx:
xxxx:xxxx
IPv6 Address (global) xxxx:xxxx:
xxxx:xxxx:
xxxx:xxxx
When [Admin Setup] is pressed
Note! The [Admin password] is required to enter this menu.
By default, Administrator password is not set.
Copy Setup
The shaded portion shows the default setup value when shipped from the factory.
Item
Default Doc.Type Doc.Type Text
Settings Text/Photo
Photo
Extra Fine
Removal for Auto
OFF
Background
1
& Show-
2
Through
3
(sTHR)
4
5
sTHR
43967002TH Rev.1
Contents
T h i s m e n u i s n o t i n d i c a t e d w h e n
[Administrator Setup] - [Network control] -
[Network Setup] - [TCP/IP] is invalid, or if [IP
version] is "IPv4".
T h i s m e n u i s n o t i n d i c a t e d w h e n
[Administrator Setup] - [Network control] -
[Network Setup] - [TCP/IP] is invalid, or if [IP
version] is "IPv4".
Contents
Set default setup of image quality.
Set default setup of background/offset
phenomenon removal.
The shaded portion shows the default setup value when shipped from the factory.
Item
Default Density -3
Settings -2
-1
0
+1
+2
+3
Zoom 100%
Automatic
Sort OFF
ON
Margin Margin OFF
ON
Left (Front) 0~±25mm
(1mm step)
0
0~±1.0inch
(0.1inch step)
Top (Front) 0~±25mm
(1mm step)
0
0~±1.0inch
(0.1inch step)
Left (Back) 0~±25mm
(1mm step)
0
0~±1.0inch
(0.1inch step)
Top (Back) 0~±25mm
(1mm step)
0
0~±1.0inch
(0.1inch step)
3. Installation
Contents
Set default setup of density.
Set default setup of Enlarge/Reduce.
Set default setup to sort copied sheets in the
order of page number.
Select the default setup whether documents
of different sizes are copied to the papers of
different sizes or not.
Set default setup of Enable/Disable binding
margin.
Set default setup of distance of movement of
copied output image toward right on the front
side of copy paper.
(Display in units of mm or display in units of
inch can be switched by changing the unit of
display on the system setup).
Set default setup of distance of movement of
copied output image toward bottom on the
front side of copy paper.
(Display in units of mm or display in units of
inch can be switched by changing the unit of
display on the system setup).
Set default setup of distance of movement of
copied output image toward right on the back
side of copy paper.
(Display in units of mm or display in units of
inch can be switched by changing the unit of
display on the system setup).
Set default setup of distance of movement of
copied output image toward bottom on the rear
side of copy paper.
(Display in units of mm or display in units of
inch can be switched by changing the unit of
display on the system setup).
111 /