Ceramic Fuel Effect Refitting; Fitting The Lower Firefront - Baxi 939 Installation And Owner's Manual

CERAMIC FUEL EFFECT REFITTING

The installer and owner guide for the ceramic fuel effect is separate from this guide.
The installer may have attached it to this guide or placed it inside. It is important that
the installer and owner guide for the ceramic fuel effect is followed correctly. If
replacing the ceramic fuel effect, where a new guide is supplied, follow the installer
and owner guide supplied with the replacement fuel effect.
Keep the replacement installer and owner guide with this owner guide for future
reference.
Decorative firefront.
For Quattro / Anthem firefronts please see section
below.
To remove the firefront, remove the 'ash pan'
(where applicable) and then lift the firefront clear.
To fit the firefront simply place the decorative
firefront on the hearth and centralise to the
appliance. Then fit the 'ash pan' (where applicable).
Quattro and Anthem firefront only
Note: Before removing the
Quattro / Anthem firefront it is
necessary to remove the
ceramic fuel effect.
Remove the fuel effect
carefully and place aside. We
recommend that the fuel effect
is removed in the reverse
order to that shown in the
fitting sections.
Remove the lower 'ash
pan' (Where applicable).
Lift the firefront clear of the
burner.
To fit the firefront, locate
the firefront as in figure 5. The
hooks should fit into the slots
on the burner tray.
The lower 'ash pan' should
be located as in figure 6.
© Baxi Heating U.K. Limited 2009.
OWNER GUIDE

FITTING THE LOWER FIREFRONT

Figure 6. Lower ''ash
pan'' location
Figure 5. Hanging the firefront
Page 37