Ceramic Fuel Effect Fitting - Baxi 748 Owner's Manual

The installer and owner guide for the ceramic fuel effect is separate from this guide. The
installer may have attached it to this guide or placed it inside. It is important that the
installer and owner guide for the ceramic fuel effect is followed correctly. If replacing
the ceramic fuel effect, where a new guide is supplied, follow the installer and owner
guide supplied with the replacement fuel effect.
Keep the replacement installer and owner guide with this owner guide for future
reference.
Battery replacement.
The igniter unit uses a 9V PP3 battery. To replace the
battery remove the firefront / lower fascia section.
Chic model -To remove the lower hanging trim
firmly hold the sides of the trim and gently pull
forward. It is held in place with magnets.
Envy and Westminster models - The lower hanging
trim is hooked in place. To remove, hold it firmly and
lift upward and forward.
1. Remove and discard the battery from the ignition
block located below the burner tray at the left side.
2. Fit the replacement battery to the ignition
block. (See figure 4). The positive terminal (+) is
to the top as you insert.
3. Replace the firefront / lower fascia section.
Chic model -The lower section of the fascia has
two tabs. Locate these into the slots in the fascia
(See figure 5). It may be necessary to re-position
the magnets that secure the lower section.
Envy model - Locate the lower section of the
fascia onto the tabs as shown in figure 6.
©
Baxi Heating U.K. Limited 2006.
OWNER GUIDE

CERAMIC FUEL EFFECT FITTING

MAINTENANCE
Figure 4. Fitting the battery
Figure 5. Fitting the lower section
to the Chic and Envy fascia
Page 11