Operating The Fire; The Oxysafe Flame Sensing & Flue Blockage Safety System; To Light The Fire - Baxi 939 Installation And Owner's Manual

Open decorative gas fire

Hide thumbs Also See for 939:

Owner's manual (14 pages)

Table of Contents

When operating your fire for the first time, some vapours may be given off which may

cause a slight odour and could possibly set off any smoke alarms in the immediate

vicinity. These vapours are quite normal with new appliances. They are totally

harmless and will disappear after a few hours use.

The Oxysafe flame sensing & flue blockage safety system.

For your safety, this appliance is fitted with a flue blockage safety device that will shut

down the appliance in the event of abnormal flue conditions. This device is NOT a

substitute for an independently mounted Carbon Monoxide detector.

The device will also automatically shut off the gas supply to the fire if the pilot flame

goes out due to lack of oxygen or for any other reason.

If this device starts to repeatedly shut off the gas, get expert advice.

This device incorporates a probe that senses that the heat from the pilot flame is

correct. If this probe is cool, the device will prevent any gas flow unless the control

knob is held in at the ignition position.

If, for any reason, the flames go out when the fire is hot or if the fire is turned off

when hot, always wait at least three minutes before attempting to relight.

To light the fire.

Depress the control knob and slowly rotate it anticlockwise to the pilot ignition

position. A 'click' will be heard as the integral piezo operates. A flame should appear

at the pilot. Keep the control knob depressed and hold the pilot ignition position for

ten seconds. When the control knob is released the pilot flame should remain lit. If a

flame does not appear at the pilot then turn the control knob clockwise to the 'OFF'

position and repeat the above.

When the pilot burner is operating properly, gradually turn the control knob anti-

clockwise to 'HIGH' position. (Depress the

knob slightly to get past the pilot ignition

position). The main burner should now light.

Depress the control knob slightly to release

from the 'HIGH' position and turn back

(clockwise) to 'LOW'. While turning, the burner

flames should gradually become lower but

remain alight. Depress the control knob

slightly to release from the 'LOW' position and

turn back (clockwise) to the Pilot ignition

position. The main burner should extinguish

but the pilot should remain alight. Depress the

control knob slightly and turn back (clockwise)

OWNER GUIDE