Burner; Ceramic Fuel Effect Refitting - Baxi 741 Owner's Manual

should be removed from the fire for cleaning.
Cleaning should be carried out in a well ventilated area or in the open air by gently
!
brushing with the pieces held away from your face so that you avoid inhaling the dust.
We do not recommend the use of a normal domestic vacuum cleaner which may
!
blow dust back into the air.
We suggest that you remove the ceramic fuel effect pieces in the reverse order to
!
that shown in this guide.

Burner.

Remove any deposits of soot or other foreign matter from the surface of the burner with
a dry soft brush. Be careful not to brush any particles into the open slots. Remove any
particles from the slots with a vacuum cleaner fitted with a soft brush attachment. Do
not poke wire, etc. into the slots in the burner.

CERAMIC FUEL EFFECT REFITTING

1. Place the ceramic base coal in the burner compartment. The bottom rear face of the
coal should rest on the angled ledges at the back of the burner compartment. The bottom
front recess edges on the coal base should locate against the tags at the front of the
ceramic support (See figure 4).
OWNER GUIDE
Figure 4. Ceramic base location
Page 9