Table of Contents
Advertisement
INSTALLER GUIDE
and set at maximum output.
2. After checking, turn off the appliance. Remove
the pressure gauge and replace the test point
sealing screw.
3. Relight the appliance. Turn to the maximum
output position and test around the sealing screw
for gas soundness with a suitable leak detection
fluid.
10.4 Fitting the burner tray trim.
1. Fit the burner tray trim over the front rim of the
burner tray. Push the trim fully down (See
Figure 18. Pressure test point
figure 19).
Figure 19. Burner tray trim
11. CERAMIC FUEL EFFECT INSTALLATION
The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the fitting guide for the ceramic fuel effect be placed
inside or attached to this guide and handed to the customer following completion of the
'Final review' section.
12. FITTING THE LOWER FIREFRONT
1. Place the lower firefront on top of the hearth centrally between the fascia.
2. On models with a two piece firefront place the lower front cover casting / ash pan
below the front casting. For the 'Coast' model see figure 20.
Page 20
Advertisement
Table of Contents
