Cleaning; Metal Parts; Ceramic Fuel Effect; Burner - Baxi 939 Installation And Owner's Manual

Turn the fire off and allow it to cool completely before attempting any cleaning. Note
that the fire will retain heat for some time after it has been turned off.
If large pieces of debris are found anywhere in the fireplace, have the chimney
inspected before further use.

Metal parts.

Clean the metal parts with a slightly damp cloth and then dry. Do not use abrasive
cleaners, they could scratch the surface.

Ceramic fuel effect .

This product uses fuel effect pieces containing Refractory Ceramic Fibres
(RCF), which are man-made vitreous silicate fibres. Excessive exposure to this
material may cause irritation to eyes, skin and respiratory tract. Consequently,
it is important to take care when handling these articles to ensure that the
release of dust is kept to a minimum.
Light coatings of soot will usually be burnt off during the normal operation of the
fire.
Should any soot accumulation become excessive, the ceramic fuel effect pieces
should be removed from the fire for cleaning.
Cleaning should be carried out in a well-ventilated area or in the open air by gently
brushing with the pieces held away from your face so that you avoid inhaling the
dust.
We do not recommend the use of a normal domestic vacuum cleaner that may
blow dust back into the air.
We suggest that you remove the ceramic fuel effect pieces in the reverse order to
that shown in the installer and owner guide supplied with the ceramic fuel effect.
This should have been placed inside or attached to this guide by the installer.

Burner.

Remove any deposits of soot or other foreign matter from the burner with a dry soft
brush. Be careful not to brush any particles into the open slots. Remove any particles
from the slots with a vacuum cleaner fitted with a soft brush attachment. Do not poke
wire, etc. into the slots in the burner.
© Baxi Heating U.K. Limited 2009.
OWNER GUIDE

CLEANING

Page 36