Fitting The Ceramic Fuel Effect; Full Operating Checks; Spillage Check - Baxi 939 Installation And Owner's Manual

9. FITTING THE CERAMIC FUEL EFFECT

The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the fitting guide for the ceramic fuel effect be placed
inside or attached to this guide and handed to the customer following completion of
the 'Final review' section.

10.1 Spillage check.

A spillage check must be made before
leaving the installed appliance with the
customer. Make this with all the ceramic
fuel effect pieces and firefronts / castings
are in position (See figure 18).
Close all doors and windows in the room
containing the appliance. Light the appliance
and set the control to the 'HIGH' position.
Leave the appliance on for five minutes. See
lighting instructions within section 7 of this
guide.
The end of the smoke match should be
level with the front face of the fireplace
opening.
The installation is satisfactory if the smoke
is drawn into the fireplace opening. If the
smoke is not drawn into the fireplace opening,
leave the appliance alight at the maximum setting for a further ten minutes and then
repeat the test. If smoke is still not drawn into the appliance disconnect the
appliance and seek expert advice.
If the above test is satisfactory, open all internal connecting doors, hatches, etc. in
the room. Keep all doors and windows that open to the outside of the building closed.
Switch on any extractor fan installed in the same room as the appliance or a
connecting room. Open all doors and other openings between the fan and the
appliance. Recheck for spillage as above. If the smoke is drawn into the appliance,
continue with the installation. If the test is not satisfactory, disconnect the appliance
and advise the customer of the cause of failure.
© Baxi Heating U.K. Limited 2009.
INSTALLER GUIDE

10. FULL OPERATING CHECKS

Figure 18. Spillage check
Page 24