Cut-Off Machine Cart; Storing The Machine - Stihl TS 410 Instruction Manual

10
10
10
1
5
1
1
Fit the starter cover (5) over the
N
studs (10)
Tighten up the nuts (1) by hand
N
4
3
Push the V - belt guard (4) into place
N
Screw in the bolt (3) and tighten up
N
Insert the water hose into the guide
N
in the V - belt guard (arrow) from the
shut-off cock towards the guard –
avoid tight radiuses
Continue as described in the chapter
"Tensioning the V - belt".
TS 410, TS 420

Cut-off machine cart

The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20
(special accessory) in a few easy steps.
The cut-off machine cart makes it easier
to
repair damaged roadways
–
apply roadway markings
–
cut expansion joints
–

Storing the Machine

If the machine is to remain out of use for
approx. 3 months or more
Drain and clean the fuel tank in a
N
well ventilated place
Dispose of fuel in accordance with
N
the regulations and having regard
for the environment
Run the engine until the carburetor
N
is dry, this helps to prevent the
carburetor diaphragms sticking
together
Remove the abrasive wheel
N
Thoroughly clean the machine
N
Store machine in a safe and dry
N
place. Protect against unauthorized
use (e. g., by children)
English
41