Table of Contents
Advertisement
3. Getting Started
3.1. Pre-requisites
Prior to configuring a communications module, ensure the unit is powered on and connected to the network.
The Communications Module can be configured from a computer with either a TCP/IP network connection or
a DB-9 Serial port. The communications module supports straight-through serial connections for basic
programming. For access to the full configurable feature set, a modern web browser will be required.
The communications module currently supports access from:
Internet Explorer 8 or greater
Firefox 3.5 or greater
3.2. Configuration Using the Web GUI
1.
Ensure both the communications module and your PC are connected to the Local Area Network. A direct
connection to the communications module will require the use of a crossover network cable.
WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2-IP are pre-configured with the following default settings:
IP Address:
Username:
Password:
2.
Configure the IP address of your PC to be on the same subnet as the communications module. For
example, 192.168.1.3
3.
Open a supported web browser and direct it to the IP address of the communications module. For
example, enter the following URL: http://192.168.1.10.
The browser prompts for authentication:
4.
Enter the default Username and Password. After authentication is successful, you are redirected to the
Home page.
5.
Further configuration of the communications module settings are examined in Section 4: Using the Web
GUI.
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com• www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2
192.168.1.10
admin
admin@123
Figure 1 Authentication Required
Configuration and Operation Manual
Page 7 of 53
Advertisement
Table of Contents
