Operations; Activating/Deactivating Auxiliary Outputs; Paging Operation; Rebooting The Communications Module - Talk-a-Phone WEBS-CM-2 Configuration And Operation Manual

Table of Contents

5. Operations

The communications module takes approximately one minute to boot. While the first and second LEDs are

flash, the unit is still booting (Refer to Figure 1 Front View). After all LEDs clear, wait for an additional twenty

seconds before initiating a call.

The communications module needs to be programmed in accordance with the instructions provided in

Chapter 4 (Refer to 4 Using the Web GUI).

To provide additional visible or audible alerts upon an event, the communications module is equipped with 3

Auxiliary Outputs. The Auxiliary Outputs can be used to connect devices such as a siren, a strobe light, a PTZ

camera, etc. These devices can then be activated and deactivated locally or remotely (Refer to 4.6.6 Auxiliary

Outputs).

The communications module can receive one-way paging messages from the WEBS Contact® server either

on the line level output or on the built-in hands-free speaker. The communications module must be registered

with the WEBS Contact® server in order to receive incoming pages.

The communications module can be rebooted using the Reset button on the communications module.

Pressing the Reset button once will reboot the communications module. The communications module can

also be rebooted via the Web GUI (Refer to 4.8 Reboot).

The communications module can be reset to factory settings using the Reset button. Press and hold the

Reset button for 10 seconds. The communications module will reboot with factory default settings.

Note: All data including IP address and username/password will be reset to factory defaults.

WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2

Configuration and Operation Manual

Page 29 of 53

Table of Contents

Webs-pa-1 Webs-pa-2