Talk-a-Phone WEBS-CM-2 Configuration And Operation Manual page 37

++ Valid values : RingBackBusy = 0 , Call waits for indefinite
++ RingBackBusy = 1 Calls waits for definite time before
++ switching to next number
++
++ Field name : TimerRingBackBusy
++ Description : Ringback busy time, call switch to next number after
++ waiting for this time, applicable when RingBackBusy = 1
++ Valid values : 1 - 60 seconds in increments of 1 sec.
++ Default value is 15 seconds
++ Note : Only applicable to Outbound Round Robin Calls
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
RingBackBusy = 1
TimerRingBackBusy = 15
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : HangupOnSilence
++ Description : Enable/Disable Hanging of call on silence
++ Valid values : HangupOnSilence = 0 - Disable
++ HangupOnSilence = 1 - Call disconnect on silence.
++
++ Field name : TimerHangupOnSilence
++ Description : Duration after which call disconnects automatically, if no
++ voice received.
++ Valid values : 10 - 360 seconds, in increments of 1 second.
++ Default value is 30 seconds
++ Note : None
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
HangupOnSilence = 1
TimerHangupOnSilence = 30
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : PagingOut
++ Description : Output device for Paging messages.
++ Valid values : PagingOut = 1 - To Handsfree Speaker
++ PagingOut = 2 - To Line Level Out (Default Value)
++ Note : None
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
PagingOut = 2
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : PagingOutGain
++ Description : Paging output gain.
++ Valid values : 1 - 20, Default value is 20
++ Note : None
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
PagingOutGain = 20
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : SIPPhoneNum
++ Description : This parameter is used to define phone number for the
++ purpose of receiving incoming calls.
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com• www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2
Configuration and Operation Manual
Page 37 of 53