Talk-a-Phone WEBS-CM-2 Configuration And Operation Manual page 22

4.7.4. Date and Time
The Date and Time page allows you to set the date and time of the communications module.
Login → Maintenance → Date & Time
To set the date and time:
1. Select Enable NTP to set the communications module to use Network Time Protocol.
2. If using NTP, enter the IP Address of the NTP Server.
3. If using NTP, select the Time Zone from the drop-down menu.
4. If manually entering the date and time, enter the Date in MM/DD/YYYY format.
5. If manually entering the date and time, enter the Time in HH:MM:SS 24-hour format.
6. Click Apply to save settings. NTP settings will automatically update the date / time.
Page 22 of 53
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2
Configuration and Operation Manual
Figure 26 Date and Time Setting
6
1
2
3
4
5