Installing Front Wheel - BMW K 1300 S Rider's Manual

Remove screw 1 and extract
the ABS sensor from its
socket.
Place motorcycle on an auxil-
iary stand; BMW Motorrad rec-
ommends BMW Motorrad rear
wheel stand.
Installing rear-wheel stand
( 98).
with center stand Generation
OA
II
Make sure ground is level and
firm and place motorcycle on
its center stand.
Raise front of motorcycle until
the front wheel can turn freely.
BMW Motorrad recommends
the BMW Motorrad front wheel
stand for lifting the motorcycle.
Mounting front wheel stand
( 97).
The left clamping device
fixes the threaded bush in
place in the front suspension.
A poorly aligned threaded bush
results in incorrect spacing be-
tween the sensor ring and the
sensor, and therefore to ABS
malfunctions or destruction of the
sensor.
To ensure the proper alignment
of the threaded bush, do not
loosen or remove the left clamp-
ing device.
Remove right-hand axle clamp-
ing screw 2.
Remove quick-release axle 3
while supporting wheel.
Roll front wheel forward to re-
move.

Installing front wheel

Malfunctions may occur
during control interventions
by ABS or ASC if a wheel other
than the standard wheel is in-
stalled.
Please see the information on
the effect of wheel sizes on the
ABS and ASC running gear con-
trol systems at the beginning of
this chapter.
Threaded fasteners not
tightened to the specified
8
91
z