Before Takeoff - Cirrus DESIGN SR20 Information Manual

Section 4
Normal Procedures

Before Takeoff

During cold weather operations, the engine should be properly
warmed up before takeoff. In most cases this is accomplished when
the oil temperature has reached at least 100° F (38° C). In warm or hot
weather, precautions should be taken to avoid overheating during
prolonged ground engine operation. Additionally, long periods of idling
may cause fouled spark plugs.
Do not takeoff with frost, ice, snow, or other contamination on
the fuselage, wing, stabilizers, and control surfaces.
1. Doors ..............................................................................LATCHED
2. CAPS Handle ................................................. Verify Pin Removed
3. Seat Belts and Shoulder Harness.................................... SECURE
4. Fuel Quantity.................................................................. CONFIRM
5. Fuel Selector ......................................................... FULLEST TANK
6. Fuel Pump................................................................................. ON
7. Flaps ...............................................................SET 50% & CHECK
8. Transponder ............................................................................. SET
9. Autopilot ............................................................................. CHECK
10. Navigation Radios/GPS ......................................... SET for Takeoff
11. Cabin Heat/Defrost ................................................ AS REQUIRED
12. Brakes ................................................................................... HOLD
13. Power Lever ................................................................... 1700 RPM
14. Alternator ........................................................................... CHECK
a. Pitot Heat............................................................................ ON
b. Navigation Lights ................................................................ ON
c. Landing Light ...................................................................... ON
d. Annunciator Lights....................................................... CHECK
e. Note ammeter remains within one needle width.
15. Voltage ............................................................................... CHECK
4-14
• WARNING •
Cirrus Design
P/N 13999-002 Info Manual
September 2011
SR20