Cirrus DESIGN SR20 Information Manual page 269

Cirrus Design
SR20
2. Connect ground wire from refuel nozzle to airplane exhaust, from
airplane exhaust to fuel truck or cart, and from fuel truck or cart to
a suitable earth ground.
3. Place rubber protective cover over wing around fuel filler.
Do not permit fuel nozzle to come in contact with bottom of
fuel tanks. Keep fuel tanks at least half full at all times to
minimize condensation and moisture accumulation in tanks. In
extremely humid areas, the fuel supply should be checked
frequently and drained of condensation to prevent possible
distribution problems.
4. Remove fuel filler cap and fuel airplane to desired level.
If fuel is going to be added to only one tank, the tank being
serviced should be filled to the same level as the opposite
tank. This will aid in keeping fuel loads balanced.
5. Remove nozzle, install filler cap, and remove protective cover.
6. Repeat refuel procedure for opposite wing.
7. Remove ground wires.
8. Remove fire extinguisher.
P/N 13999-002 Info Manual
September 2011
Handling, Servicing, Maintenance
• Note •
• Note •
Section 8
8-23