Cirrus DESIGN SR20 Information Manual page 336

Section 9
Supplements
Switch to Normal from the Standby Screen
SkyWatch must be switched out of STBY to display traffic information.
The ability to switch out of STBY on the ground is useful for scanning
the airspace around the airfield prior to takeoff. Using the GNS 430
controls:
1. Turn the cursor on and highlight STBY.
2. Use the small PUSH CRSR knob to select OPER?
3. Press the ENT key to place SkyWatch in the OPER (operational)
mode. SkyWatch will switch into the 6 nmi display range.
Switch into Standby from the Traffic Screen
SkyWatch cannot be switched to Standby while airborne. With the
airplane on the ground, use the GNS 430 controls as described below:
1. Turn the cursor on and highlight OPER.
2. Use the small PUSH CRSR knob to select STBY?
3. Press the ENT key to place SkyWatch in the STBY (standby)
mode.
Change Altitude Display
1. From the Traffic Screen, turn the cursor on, highlight the current
mode, and use the small PUSH CRSR knob to cycle through the
options.
2. With each turn, the display changes to display the traffic in the
selected display range (ABV, look up; NRM, normal: BLW, look
down; or UNR, unrestricted). Refer to the L-3 Avionics Systems
SkyWatch Traffic Advisory System Model SKY497 Pilot's Guide P/
N 009-10801-001 Rev B (6/6/00) or later for information regarding
the display ranges.
Respond to Traffic Advisories
1. When the SkyWatch issues a TA (Traffic Advisory), visually scan
outside for the intruder aircraft. Call ATC for Guidance. If you
visually acquire the intruder aircraft, use normal right-of-way
procedures to maintain separation.
4 of 6
• Note •
Cirrus Design
SR20
P/N 11934-S15
Revision 01: 10-12-05