Cirrus DESIGN SR20 Information Manual page 319

Cirrus Design
SR20
Roll and pitch information are displayed on attitude indicator.
Autopilot Flight Director is not implemented in this installation.
Section 2 - Limitations
1. Autopilot operation is prohibited above 185 KIAS.
2. The autopilot must not be engaged for takeoff or landing.
3. The autopilot must be disengaged for missed approach, go-
around, and balked landing.
4. Flaps must be set to 50% for autopilot operation in Altitude Hold at
airspeeds below 95 KIAS.
5. Flap deflection is limited to 50% during autopilot operations.
6. The autopilot must be disconnected in moderate or severe
turbulence.
7. Minimum engage height for the autopilot is 400 ft AGL.
8. Minimum speed with the autopilot engaged is 1.2V
configuration.
9. For VOR/GPS and ILS glideslope and localizer intercept, capture,
and tracking, the following limitations apply:
a. The autopilot must be disengaged no later than 100 feet below
the Minimum Descent Altitude.
b. The autopilot must be disconnect during approach if course
deviation exceeds 50%. The approach should only be
continued by "hand-flying" the airplane.
c. 12 knot maximum crosswind component between the missed
approach point and outer marker.
d. The intercept of the localizer shall occur at least 5 miles
outside of the outer marker.
e. If the crosswind component is greater than 12 knots and less
than 17 knots, the intercept shall occur at least 10 miles
outside of the outer marker.
f. The intercept angle shall be no greater than a 45-degree
intercept.
P/N 11934-S13
Revision 04: 08-15-07
Section 9
Supplements
for the given
s
3 of 16