Cirrus DESIGN SR20 Information Manual page 91

Cirrus Design
SR20
10. Nose, Left Side
a. Landing Light............................................................. Condition
b. Engine Oil......... Check 6-8 quarts, Leaks, Cap & Door Secure
c. Cowling.....................................................Attachments Secure
d. External Power ..................................................... Door Secure
e. Exhaust Pipe .....................Condition, Security, and Clearance
11. Left Main Gear and Forward Wing
a. Wheel fairings....................... Security, Accumulation of Debris
b. Tire ............................................Condition, Inflation, and Wear
Serials 1005 through 1592 after Service Bulletin SB 2X-32-14
and airplane serials 1593 and subsequent: Clean and inspect
temperature indicator installed to piston housing. If indicator
center is black, the brake assembly has been overheated. The
brake linings must be inspected and O-rings replaced.
c. Wheel and Brakes ....... Fluid Leaks, Evidence of Overheating,
General Condition, and Security.
d. Chocks and Tiedown Ropes........................................Remove
e. Fuel Drains (2 underside) ............................ Drain and Sample
f. Cabin Air Vent......................................................Unobstructed
g. Fuel Cap....................................... Check Quantity and Secure
h. Leading Edge and Stall Strips ................................... Condition
12. Left Wing Tip
a. Fuel Vent (underside) ..........................................Unobstructed
b. Pitot Mast (underside) ................. Cover Removed, Tube Clear
c. Strobe, Nav Light and Lens ..................Condition and Security
d. Tip ......................................................................... Attachment
13. Left Wing Trailing Edge
a. Flap And Rub Strips (If installed)..........Condition and Security
b. Aileron .................................................. Freedom of movement
c. Hinges, actuation arm, bolts, and cotter pins ................Secure
P/N 13999-002 Info Manual
September 2011
• Note •
Section 4
Normal Procedures
4-9