Power Plant Limitations; Engine - Cirrus DESIGN SR20 Information Manual

Section 2
Limitations

Power Plant Limitations

Engine

Teledyne Continental ............................................................ IO-360-ES
Power Rating ........................................................ 200 hp @ 2700 rpm
Maximum RPM .......................................................................2700 rpm
Oil:
Oil Temperature.................................... 240° F (115° C) maximum
Oil Pressure:
Minimum................................................................................ 10 psi
Maximum............................................................................. 100 psi
Approved Oils:
Engine Break-In: For first 25 hours of operation or until oil
consumption stabilizes use straight mineral oil conforming to MIL-
L-6082. If engine oil must be added to the factory installed oil, add
only MIL-L-6082 straight mineral oil.
After Engine Break-In: Use only oils conforming to Teledyne
Continental Specification MHS-24 (Ashless Dispersant Lubrication
Oil) or MHS-25 (Synthetic Lubrication Oil). Refer to Section 8 - Oil
Servicing. Oil viscosity range as follows:
All Temperatures ..............................................15W-50 or 20W-50
Above 40° F (4° C) .............................................. SAE 50 or 20W50
Below 40° F (4° C) ................. SAE 30, 10W-30, 15W50, or 20W50
Fuel Grade ................ Aviation Grade 100 LL (Blue) or 100 (green)
Refer to General Limitations – Fuel Limits in this section for
operational limitations regarding fuel and fuel storage.
2-6
• Note •
Cirrus Design
P/N 13999-002 Info Manual
September 2011
SR20