Table of Contents
Advertisement
Installation
Installation
This spray gun can spray most coatings or fin-
ishes currently being used for small compo-
nent plastic, wood and metal finishing
applications, while easily operating from paint
delivery systems, such as pressure pots or
remote pumps for production line operation.
The air regulator must have a minimum air flow
capacity of 30 scfm at 100 psi (0.7 MPa,
7.0 bar) air pressure.
Ventilate Spray Booth
To prevent hazardous concentrations of toxic
and/or flammable vapors, spray only in a prop-
erly ventilated spray booth. Do not operate the
spray gun unless ventilation fans are
operating.
Check and follow all national, state, and
•
local codes regarding air exhaust velocity
requirements.
Check and follow all local safety and fire
•
codes.
12
Configure Gun and Manifold
Guns with Manifold
See F
. 1. The gun is shipped with a fluid plug
IG
(25). To use the gun in a circulating system, do
not install the plug. In a non-circulating system,
install the plug as shown to minimize flush
time.
1. Connect the fluid supply line to one fluid
port fitting and the fluid return line to the
other. The manifold fluid ports are
reversible.
2. Install the gun on the manifold, using the
two screws. Torque the screws evenly to
50 in-lb (5.6 N•m).
Do not install when used in circulating systems.
1
F
. 1: Guns with Manifold
IG
25
1
TI14429A
313869K
Advertisement
Table of Contents
