Table of Contents
Advertisement
Installation
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod
[0.75 in. (19 mm) diameter maximum], insert
the bar (A) through the hole in the manifold as
shown in F
. 3.
IG
NOTE: Use the 1/8 in. alignment slot (P) to
assist in orienting the gun.
Secure the gun to the bar by tightening the
mounting screw (B).
B
F
. 3: Reciprocating Arm Mount
IG
Stationary Support
To mount the gun on a stationary support,
refer to F
. 4 and to the correct mounting hole
IG
layout for your gun, page 34 - 35.
1. Align the gun or manifold with the align-
ment pins. Locate alignment slot and holes
per the mounting hole layout.
2. Secure the gun to the support with two M8
x 1.25 capscrews (C). The screws must be
long enough to engage the threaded holes
to a depth of 1/4 in. (6 mm).
14
A
TI14433A
P
C
Guns with manifold
C
Guns without manifold
F
. 4: Stationary Support Mount
IG
TI14434A
TI14435A
313869K
Advertisement
Table of Contents
