Replacing The Seat Frame With A Manual Tilt Module (From Dec. 2010) - Invacare Storm4 Series Service Manual

SERVICE MANUAL
·
Remove the pin retainer (3).
·
Remove the pin (2).
·
Fold back the entire seat.
·
Keep a firm hold on the seat and the seat support whilst loosening and removing the four torx
screws (1).
·
Lift the seat and the seat support from the vertical column.
Refitting the seat carrier:
·
Refit the parts in reverse order.
·
To conclude, check all the mobility aid functions.

8.15.1.2 Replacing the seat frame with a manual tilt module (from Dec. 2010)

CAUTION: Danger of crushing!
The seat/seat support are very heavy. Injury hazard to hands and feet!
· Use proper lifting techniques.
Requirements:
· T40 torx wrench
· oblique pliers
· cable ties
Dismantling the seat support:
·
Remove the legrests.
·
Remove the armrests.
·
Remove the seat cushion.
·
Remove any existing cable ties holding the cables on the remote or lighting. Remove the
cables from the stuck on clamps.
·
Loosen the cap nuts of the headlight mountings using an 8 mm jaw spanner (see chapter 8.7.7
or 8.7.9).
·
Put the headlight and the mounting in a safe place on the rear part of the battery compartment
cover.
·
Remove the connecting cable to the chassis from the remote or form the optional actuator
module.
·
Remove the cable or cables so that there is no longer any cable connection between the seat
and the chassis.
150
®
Invacare - STORM
4 ®
Series