Electronics Modules - Invacare Storm4 Series Service Manual

SERVICE MANUAL
Directly under the seat:
·
Actuator module (1)
The actuator module is optional. If available, it controls the electric leg supports, the electric tilt
module and the electric back adjustment.
·
Lighting/actuator module CLAM (7)
The CLAM module is optional. It is only available if the mobility aid is equipped with electric
adjustment options.
The CLAM module is mounted under the seat frame.
Underneath the rear cover:
·
Light terminal block (2)
The light terminal block is in front of the actuator module (3). The light terminal block is
optional. It is only available if the mobility aid is fitted with lighting.
·
Actuator module (3)
The actuator module is on the top of the battery compartment. The actuator module is optional.
It is only available if the mobility aid is fitted with a lifter.
·
Power module (4)
The power module is at the rear of the battery compartment.
·
G-Trac (5)
The G-Trac sensor is located in the rear on the right, next to the battery box.
·
True Track® Plus power module (6)
The Track® Plus power module is optional The True Track® Plus power module is at the rear
of the battery compartment.
4.2

Electronics modules

A variety of electronics modules can be fitted to the mobility aid.
Before you connect mobility aid components such as adjusting motors/actuators or motors, please
begin by ascertaining which module is installed. Please refer to the following table for an overview.
Electronic module
20
Designation
Power module
ACS2 PMA90L
Actuator module
ACT 2 / ACT 4
Lighting PCB
®
Invacare
Notes
The following remotes can be connected:
- REM 24 SD
- REM A
- REM B
- REM 550
The actuator module is optional.
The lighting PCB is optional.
4 ®
- STORM Series