Adjusting The Seat Height; 12°-Tilt Module With Standard Seat Or Flex 2 Seat - Invacare Kite Service Manual

SERVICE MANUAL
10.1

Adjusting the seat height

10.1.1 12°-Tilt Module with Standard seat or Flex 2 seat
Requirements:
· 4 mm Allen wrench
· 13 mm open-ended wrench
· Screwdriver, flat, width approx. 6 mm
· Small hammer
WARNING: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
· Let a second person help you.
Overview of the fixations points, depending on the desired seat height and the seat which is
installed:
Seat
height
in cm
42
44
46
48
Seat
height
in cm
46
48
50
Adjusting the actuator holder on the chassis
Detailed instructions on the actuator can be
found in chapter 8.15.
·
Use the screwdriver to remove the SL-
retainer of the lower holding bolt.
·
Place a support under the seat.
·
Pull the holding bolt.
·
Adjust the actuator with holding bolt to the
desired height, according to the above table.
·
Secure the holding bolt with the SL-retainer
108
12° tilt with standard seat
A B C
X
X
X
12° tilt with Flex 2 seat
A B C
X
X
Actuator holder
D a b
X
X
X
Actuator holder
D a b
X
X
®
Invacare - Kite
c d
X
X
c d
X
X