®
Invacare
- STORM
8.9
Replacing the front wheel carrier
8.9.1
Replacing the front wheel carrier (only Standard Storm
WARNING: Danger of crushing!
The mobility device is very heavy. Injury hazard to hands and feet!
· Use proper lifting techniques.
Injury hazard caused by uncontrolled movement of the mobility device!
· Switch the power supply off (ON/OFF key).
· Engage the drive.
· Before raising the vehicle, secure the wheels by blocking them with wedges.
Requirements:
· 5 mm Allen key
· 17 mm Allen key
· blade screwdriver
· 25 Nm torque wrench
· 200 Nm torque wrench
· long wooden blocks, min. 14 x 14 x 30 cm
Dismantling the front wheel carrier:
·
Jack up the mobility aid using several wooden blocks. Use proper lifting techniques.
·
Use a screwdriver to remove the plastic cap (6).
·
Loosen and remove the Allen screw (2) with a 5 mm Allen key.
·
Loosen and remove the Allen screw (5) with a 17 mm Allen key.
·
Remove the two Nord-Lock lock washers (4).
·
Remove and replace the front wheel carrier (3).
4 ®
Series
SERVICE MANUAL
4
)
105