Adjusting The Seat Depth With Replacing The Seat; Support Plate - Invacare Storm4 Series User Manual

5. Repeat these operations on the other side of the seat.
6. Undo and remove the two Allen screws (5) including
washers.
Assembly
1. Pull the seat support to the required length so that
the Allen screws (5) can be inserted in the holes in
accordance with the table (see above).
2. Insert the Allen screws (5) including washers again and
tighten them.
3. Fit the two Allen screws (8) which are located at the
rear of the seat support, and connect them with the
crossmembers (4). You must be using other holes within
the 3 hole pairs for the screws than you did during
dismantling.
4. Refit all the parts you have removed.
1529686-AA

5.15.4 Adjusting the seat depth with replacing the seat

support plate

Fig. 5-60 Exploded drawing of seat support
Disassembly
1. Remove the legrests.
2. Remove the armrests.
3. Remove the seat cushion.
4. Remove any cable ties which hold cables from the
remote or lighting which have been fitted. Remove the
cables from any clips which have been glued on.
5. Undo the cap nuts on the headlight holders with an
8 mm jaw spanner.
6. Place the headlights including their holders safely on
the rear section of the battery box cover.
Setup
71