CanyCom S25A Operator's Manual page 40

7
Item
Check for cracks, damage, or de-
・
formation of cooling fan, cover,
duct.
Cooling system
Check for loose mounting bolts
・
or nuts of cooling fan, cover.
Charging
Use AMmeter to check for any ab-
・
system
normality in function.
Check that electrolyte level is
・
within specified range.
Battery
Check for loose or corroded ter-
・
minals.
Check for loose connections.
・
Wiring
Check for damaged wiring.
・
Drive machine and operate travel
・
lever to FORWARD, REVERSE,
and left and right turns, check
actuation, check for abnormal
noise or abnormal generation of
heat.
HST pump
Check oil level inside hydraulic
・
tank.
Check for dirty oil.
・
・ Check for oil leakage from around
hydraulic tank.
Check for cracks, deformities,
・
wear.
Drive machine and check for ab-
・
normal noise or abnormal gen-
eration of heat from shaft area.
Check for loose or missing mount-
Sprocket
・
ing bolts and nuts.
idler, roller
upper roller
Check for oil leakage from around
・
axle.
Drive machine and check that
・
roller bracket moves smoothly in
accordance with ups and downs
in ground surface.
Check for cuts or damage in steel
・
cord
Check for cut, deteriorated, or
・
Track
worn rubber
Check for missing or broken core
・
Check track tension
・
Fill inside of track tensioner cylin-
・
der with grease and check opera-
Track tensioner
tion of system
Maintenance
Content of inspection
There must be no cracks,
damage, or deformation.
There must be no loose
ounting bolts or nuts.
Must work properly.
Must be within specified
range.
There must be no loose-
ness or marked corrosion.
There must be no loose
connections.
There must be no dam-
age.
Must work normally,
there must be no abnor-
mal noise or abnormal
generation of heat.
Oil level must be correct.
There must be no marked
dirt.
There must be no oil leak-
age .
No cracks, deformaties,
or noticeable wear.
No abnormal noise or
heat.
There must no loose or
missing mounting bolts
and nuts.
There must be no oil leak-
age.
Must move smoothly.
There must be no cuts or
marked damage
There must be no marked
cutting, deterioration, or
wear
There must be no missing
core
Tension must not be too
loose or too tight
Must work properly
-33-
Inspection Inspection
interval interval
Remarks
◯
◯
Please contact your
CANYCOM represent-
◯
ative for inspection
Inspection/adding:
◯ ◯
See page 45
◯ ◯
◯ ◯
◯ ◯
◯ ◯ ◯
Inspection/change:
◯ ◯
See page 41
Inspection/change:
◯ ◯
See page 41
◯ ◯
◯ ◯ ◯
◯ ◯ ◯
◯ ◯ ◯
◯ ◯ ◯
◯ ◯
◯ ◯ ◯
◯ ◯ ◯
◯ ◯ ◯
Adjustment: See
◯ ◯ ◯
page 52
◯ ◯
7