Advertisement
CARF-Models Co., Ltd, Contact email: techsupport@composite-arf.com
inserted in the latch. Remember to drill
the holes in the latch equal to the size of
the insert screws.
Cut spacers to insert under the stand-
offs, keeping them vertical to the cowling
on the fuse, and test fit the standoffs to
make sure they touch the cowling sides
(you may have to adjust the wood cowl-
ing alignment inserts installed at the
factory in the middle of the cowling, for
enough slack to be easily installed) After
test fitting, use a thixotropic epoxy glue
mix and glue the standoffs to the cowl-
ing. You will have to cut out cooling exit
holes in the rear of the cowling, see the
supplied photos.
Page 8
Instruction Manual "Valiant" (Draft Version)
Advertisement
