Advertisement
CARF-Models Co., Ltd, Contact email: techsupport@composite-arf.com
#3 Carefully place the strake on the glue
line, hold it in place and let it set ,after the
glue sets on the base, glue the upper portion
to the fin.
#4 Set the fuselage on a stand. Using an
incidence meter set the fuse to zero measur-
ing from the canopy base. Next insert the
horizonal separator in the slot on the strake
and set the separator to 2 degrees negative.
Tack it in place. Then turn the fuse over and
glue the seperator in place using thick C/A.
I you decide to fly the airplane before you
install the Strake there is no need to worry
about trim changes, there will not be any!
Page 23
Instruction Manual "Valiant" (Draft Version)
Advertisement
