Advertisement
CARF-Models Co., Ltd, Contact email: techsupport@composite-arf.com
#5 After the rear latch is hardened,
install the canopy. Find the rear pin
indent and drill the hole for the rear latch
pin.
#6 Using a Dremel™ barrel grinder, drill
a hole towards the front of the canopy
through the top skin. Then, use a 1/16
drill, after aligning the canopy, and
precisely drill a pilot hole through the
canopy and fuse flashing, going through
the light ply rails.
#7 Now, remove the canopy and drill
the pilot hole with a 1/8" drill bit. Insert a
piece of yellow Ny-rod® and glue it in
place with C\A from the bottom side.
#8 Reinstall the canopy and, using a
self-tapping screw, screw the canopy
down to the fuse for a final fit test.
Page 11
Instruction Manual "Valiant" (Draft Version)
Advertisement
