Advertisement
CARF-Models Co., Ltd, Contact email: techsupport@composite-arf.com
using an applicator or a brush, apply the
glue to the firewall.
When the firewall glue is completely
hardened, drill the holes in the motor
mount through the firewall and install the
blind nuts. Relieve the flashing on the
engine compartment so the motor can-
not touch or rub. See the photos. Drill
the relief hole for the needle valve and
fuel elbow's to complete the installation.
After the motor is installed, install the
exhaust system. Add a piece of 2mm
plywood across the inside of the fuse
where the mounting for the pipe discon-
nects. Screw in for rigidity and noise
reduction.
Page 6
Instruction Manual "Valiant" (Draft Version)
Advertisement
