Program Selector; Water Temperatures - Simpson SWT5541 User Manual

8

PROGRAM SELECTOR

3.1
KNOB
Turn the Program Selector knob to
choose the wash program you
want. The table "Your Program
Guide" shown on page 12 will help
you in selecting the right program.
The Program Selector knob is not a
timer. Once you select a wash
program, the Program Selector
knob will stay at that position for
the whole wash cycle.
When you choose the Woollens
and Bedding program, the Deep
Rinse option is automatically
selected for you. You will NOT be
able to select and use Eco Rinse
with these two programs.

WATER TEMPERATURES

3.2
BUTTON
For each wash program your
washing machine automatically
selects a suitable fill water
temperature. If you want to use a
different wash water temperature,
press the Temperature button
repeatedly.
The water temp lights will tell you
the temperature for each press of
the button.
You have four temperatures to
choose from Very Hot, Hot, Warm
and Cold.
The temperature of warm water will
depend on the temperature and
pressure of your hot and cold water
supplies. The recommended
temperature for warm is 35°C.
NOTE:
You can adjust the flow rate of the
water supplies to adjust the Warm
temperature. All rinse water
temperatures are cold.
Always check your label for the
washing temperature symbols
which the International Care
Labelling Code now uses
Cold, Warm,
NOTE:
If you have a cold water connection
ONLY and the hot inlet valve is
capped off (refer installation
instructions) you must select Cold
washes only. To fill detergent, you
must follow steps as below:
1. Measure the correct amount of
powder detergent by following
the recommendations on the
package.
2. Mix powder detergent in one
litre of hot or warm water.
3. Add the pre-mixed detergent to
the wash load.
move around
agitator
Hot.