Product Features; Power Failure Recovery - Simpson SWT5541 User Manual

6
2.2

PRODUCT FEATURES

The Simpson wash system
1) Wash operation
The agitator & bowl rotates while it is filled
with water to immerse the clothes.
The agitator then rotate to move the
clothes so that the detergent can be
dissolved and activated at the selected
water temperature.
2) Agitation and dilution
After the wash operation is completed,
the bowl is filled with more water. The
agitator then moves in an energy efficient
mode, generating additional mechanical
actions.
Auto Clear Unbalance
The washing machine can stop during the
spin stage of a wash or spin because of
an out of balance condition. Out of
balance during spin is caused by an
uneven distribution of clothes in the wash
bowl. If the washing machine detects this
problem, it will try to clear itself by
following the steps below:
1. Stop spinning then starts filling to the
selected water level.
2. Agitates for 3 minutes to redistribute
the clothes.
3. Drains the water.
4. Starts the spin cycle again.
NOTE
-
If the machine detects the problem
again, it will repeat self clearing steps
one more time. If problem reoccurs the
third time, "
with 3 short beeps repeated 3 time
every 15 seconds to get your attention.
" will be displayed along
To rectify the out of balance condition,
open the lid and wait until the machine
stops spinning, then redistribute the
clothes evenly in the space between the
agitator and wall of the wash bowl. Close
the lid and press the "Start/Pause" button
to continue the spin stage
NOTE
-
If you have frequent out of balance
interruptions, it may be due to your
washing machine not standing firm and
level on the floor. This can be corrected
by adjusting the washing machine legs
as described in the Installation Instruc-
tions sheet supplied with your machine.
- If "Eco" rinse option selected, this
function will not operate.
-
This function will not operate in "Tub
Cleaning" and Drain + Spin" programs.
-
If "Extra" rinse option is selected, self
clearing steps will be repeated up to 6
times.

Power Failure Recovery

When there is power failure while
machine is washing or rinsing or
spinning. The machine tries to save the
settings at which stage the machine is
doing and then when the power returns
back the machine will starts washing
from the stage where it is left off.
Button Response and Lights
Always press buttons gently. Watch the
lights on the control panel to see the
effect pressing a button or turning a
program selector knob has, and listen
for "BEEPS".
When you press a button you will get a
short "BEEP" to acknowledge the entry. If
the option is not available at the time, the
machine will not allow you to select it, and
you will here the three short "BEEP" to
remind you the option is not available and
the display will show " " and flashing.