Engine Oil Pressure Regulator - SeaDoo Rotax 1503 4-Tec 2005 Engine Shop Manual

Clean both contact surfaces of oil strainer cover.
Check and clean the oil inlet and outlet area for dirt
and other contaminations.
TYPICAL
1. Oil inlet to the oil pump
Installation
For installation, reverse the removal procedure.
Position screws according to their length as
shown.
TYPICAL
1. Screws M6 x 25
2. Screws M6 x 85
Torque suction pump cover screws to 10 N•m
(89 lbf•in) as per sequence illustrated below. Ap-
ply Loctite 243 (P/N 293 800 060) on threads.
SMR2005-035
Section 01 ENGINES (1503 4-TEC)
Subsection 04 (LUBRICATION SYSTEM)
ENGINE OIL PRESSURE
REGULATOR
The oil pressure regulator is located on the bottom
of the PTO housing.
TYPICAL — NATURALLY ASPIRATED ENGINE
1. Oil pressure regulator
www.SeaDooManuals.net
49