Pto Seal - SeaDoo Rotax 1503 4-Tec 2005 Engine Shop Manual

Section 01 ENGINES (1503 4-TEC)
Subsection 03 (PTO HOUSING AND MAGNETO)
TYPICAL
1. Screws M6 x 35
2. Screws M6 x 85
Tightening sequence for screws on PTO housing
is as per following illustration.
Reinstall LH engine support. Apply Loctite 243
(P/N 293 800 060) on screw threads then torque
to 24 N•m (17 lbf•ft).
Remove block under engine.
Refill engine with oil and cooling system with
coolant. Refer to LUBRICATION and COOLING
SYSTEM sections of the appropriate VEHICLE
SHOP MANUAL.
34

PTO SEAL

Inspection
Check the PTO seal no. 22 and O-rings no. 10 on
the PTO housing. If brittle, hard or damaged, or if
you see a sign of oil leakage, replace it.
Removal
Place rags under PTO housing to prevent spillage.
If spillage occurs, clean immediately with the pul-
ley flange cleaner (P/N 413 711 809) to prevent oil
stains.
Remove:
– Oetiker clamp no. 11 located close to the PTO
housing
– PTO seal no. 22.
TYPICAL
1. Oetiker clamps
2. PTO seal
www.SeaDooManuals.net
smr2005-032