Coupling; Stator - SeaDoo Rotax 1503 4-Tec 2005 Engine Shop Manual

Installation
Reinstall removed parts in the reverse order.
CAUTION: When installing PTO seal on super-
charged engines, make sure to position the
Oetiker clamps as shown in the picture.
1. Oetiker clamps

COUPLING

Removal
Lock crankshaft with locking tool (P/N 529 035
821). Refer to CYLINDER BLOCK section.
Remove:
– PTO seal as described above
– coupling no. 12 using impeller remover/installer
(P/N 529 035 820).
529035820
CAUTION: Apply some oil on the tool to protect
the seal located in the PTO coupling.
smr2005-032
Section 01 ENGINES (1503 4-TEC)
Subsection 03 (PTO HOUSING AND MAGNETO)
TYPICAL
Inspection
Check if seal no. 13 is brittle, cracked or hard.
Check coupling for worn splines.
If damaged, replace faulty part.
Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
Torque PTO coupling to 250 N•m (184 lbf•ft). Ap-
ply Loctite anti-seize (P/N 293 800 070) on threads.

STATOR

Removal
Remove:
– PTO housing (refer to PTO HOUSING RE-
MOVAL elsewhere in this section)
– holding plate no. 14 with CPS no. 15
www.SeaDooManuals.net
35