1. Oil inlet to the oil pump
Installation
For installation, reverse the removal procedure.
Refill engine at the proper level with the recom-
mended oil. Refer to LUBRICATION SYSTEM in
the appropriate VEHICLE SHOP MANUAL for the
procedure.
SUCTION PUMP OIL STRAINER
NOTE: The oil strainer does not need to be
cleaned at every oil change. Clean it during other
inspections, especially when the engine is disas-
sembled.
Removal
– Remove ventilation hose no. 7.
SMR2005-035
Section 01 ENGINES (1503 4-TEC)
Subsection 04 (LUBRICATION SYSTEM)
TYPICAL — NATURALLY ASPIRATED AND
SUPERCHARGED ENGINES
1. Ventilation hose
TYPICAL — SUPERCHARGED INTERCOOLED ENGINE
1. Ventilation hose
– Disconnect wiring harness from TOPS valve
no. 8 and oil separator pressure switch (OSPS)
no. 9.
– Detach intake hose from throttle body (naturally
aspirated engine only).
– Remove other required parts from vehicle to
access the oil suction pump cover.
– Remove retaining screws no. 10 and no. 11.
– Place rags under cover to prevent spillage. If
spillage occurs, clean with the pulley flange
cleaner (P/N 413 711 809) .
www.SeaDooManuals.net
47