Rotor And Trigger Wheel - SeaDoo Rotax 1503 4-Tec 2005 Engine Shop Manual

Section 01 ENGINES (1503 4-TEC)
Subsection 03 (PTO HOUSING AND MAGNETO)
TYPICAL
1. CPS screws
2. Holding plate
3. CPS
– screws no. 16
– stator no. 17.
TYPICAL
1. Stator screws
2. Stator
Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
NOTE: There is only one position for the stator
(notch in the magneto housing cover).
36
TYPICAL
1. Notch for stator
Place the rubber grommets on both cables in the
proper notches at the PTO housing.
TYPICAL
1. Grommet on CPS cable
2. Grommet on stator cable
Apply Loctite 243 (P/N 293 800 060) on threads.
Torque stator and CPS screws to 10 N•m
(88 lbf•in).

ROTOR AND TRIGGER WHEEL

Removal
Lock crankshaft with locking tool (P/N 529 035
821). Refer to CYLINDER BLOCK section.
Remove:
– PTO housing
– hexagonal screws no. 18 retaining rotor.
www.SeaDooManuals.net
smr2005-032