Engines (1503 4-Tec); Leak Test; Procedures; Preparation - SeaDoo Rotax 1503 4-Tec 2005 Engine Shop Manual

LEAK TEST

SERVICE TOOLS
Description
Drive shaft adapter ............................................................... 529 035 892 ............................................. 2
Drive shaft adapter ............................................................... 529 035 985 ............................................. 2
SERVICE PRODUCTS
Description
Molykote 111........................................................................ 413 707 000 ............................................. 4

PROCEDURES

PREPARATION

The procedure has to be done when engine op-
erating temperature of approx. 70°C (158°F) is
reached.
WARNING
Prevent burning yourself due to handling on
the hot engine.
Remove:
– any parts to have access to engine
– safety lanyard
WARNING
Safety lanyard must be removed to prevent
engine to be cranked while fuel rail is re-
moved to prevent fuel to be sprayed out.
Fuel is flammable.
– jet pump (refer to JET PUMP in the appropriate
VEHICLE SHOP MANUAL)
– coolant tank cap
SMR2005-032
Section 01 ENGINES (1503 4-TEC)
To prevent burning yourself only remove the
coolant tank cap by wearing the appropriate
safety equipment.
– oil dipstick
1. Oil dipstick
– Unplug ignition coil and pull it out
– spark plug.
NOTE: Ignition coil may be used as an extractor.
www.SeaDooManuals.net
Subsection 01 (LEAK TEST)
Part Number
Part Number
WARNING
Page
Page
1