Oil Spray Nozzle - SeaDoo Rotax 1503 4-Tec 2005 Engine Shop Manual

TYPICAL
1. Starter drive bearing
TYPICAL
1. Starter drive support
CAUTION: Be sure not to forget the distance
washer, disc springs and washer on the starter
drive shaft when assembling.

OIL SPRAY NOZZLE

Supercharged Engines Only
Removal
Remove the PTO housing as described above:
– Turn oil spray nozzle no. 23 by using a grip plier
to crack the Loctite.
CAUTION: Do not try to pull out the oil spray
nozzle with a plier. This may damage the force
fit in the PTO housing.
– Fix supercharger spray nozzle remover tight on
oil spray nozzle.
smr2005-032
Section 01 ENGINES (1503 4-TEC)
Subsection 03 (PTO HOUSING AND MAGNETO)
1. Oil spray nozzle
2. Spray nozzle remover
– Remove oil spray nozzle carefully by using a
slide hammer puller.
Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
Apply Loctite 648 (P/N 413 711 400) on oil spray
nozzle fitting surface.
CAUTION: The oil spray nozzle must be in ex-
act position to supply enough oil to the super-
charger. Any other installation will lead to a su-
percharger damage.
Only use supercharger spray nozzle installer to
push in the nozzle no. 23. Use retaining screw
hole to ensure the exact position.
1. Spray nozzle installer
2. Screw hole for positioning
www.SeaDooManuals.net
39