Martin Stage Cyclo User Manual page 16

blue, then back through purple to red in a continuous cycle (see example in
Figure 10).
100%
Red
50%
Blue
0%
Setting a static color display
In stand-alone operation, a static (non-changing) color display can be set by
pausing the program at the point where it is showing the desired color.
Either one color or a mix of two colors can be "frozen" in this way.
To set a static color display:
1. Activate the color you wish to display (if you wish to display a two-color
mix, activate these two colors) on DIP switch pins 1 to 4.
2. Set the fixture as master by setting DIP switch pin 9 to OFF.
3. Set DIP switch pins 5 and 6 to ON to activate the slowest program speed.
4. Set DIP switch pin 7 to OFF to activate crossfading and DIP switch pin 8
to OFF to activate the program.
5. When the desired color or color mix appears, pause the program by
moving DIP switch 8 to ON. This color will remain "frozen" until DIP
switch 8 is moved to OFF.
Note that the paused color is lost when the fixture is powered off. When
powering the fixture on again, DIP switch pin 8 must be moved to OFF
before the program will start.
16
100% Blue 100% Blue
50% Red 50% Red
50% Blue 50% Blue
0% Red 0% Red
Blue
Purple
Figure 10: Crossfading between red and blue
Stage Cyclo user manual
100% Red 100% Red
0% Blue 0% Blue
Red
Time