Industry Canada - Ubiquiti airMAX NanoStationM2 Quick Start Manual

NanoStation M/NanoStationloco
™
NOTE: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operations of this equipment in a
residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense.
For MPE and antenna usage details, please visit our website at
www.ubnt.com/products

Industry Canada

This Class A digital apparatus complies with Canadian ICES-003.
To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
This device has been designed to operate with the antennas listed below, and
having a maximum gain of 25 dBi*. Antennas not included in this list or having
a gain greater than 25 dBi are strictly prohibited for use with this device. The
required antenna impedance is 50 ohms.
* Model: NanoStation antenna gain is 25 dBi.
The maximum antenna gain permitted for devices in the bands
5250-5350 MHz and 5470-5725 MHz shall comply with the e.i.r.p. limit; and the
comply with the e.i.r.p. limits specified for point-to-point and non point-to-point
operation as appropriate.
Users should also be advised that high-power radars are allocated as primary
5650-5850 MHz and that these radars could cause interference and/or damage
to LE-LAN devices.
Cet appareil numérique de la classe A est conforme à la norme NMB-003
Canada.
Pour réduire le risque d'interférence aux autres utilisateurs, le type d'antenne
et son gain doivent être choisies de façon que la puissance isotrope
communication réussie.
Cet appareil est conforme à la norme RSS Industrie Canada exempts de licence
1. Cet appareil ne peut pas provoquer d'interférences et
2. Cet appareil doit accepter toute interférence, y compris les interférences
qui peuvent causer un mauvais fonctionnement du dispositif.
12
M Quick Start Guide
™