Telstra Commander E105 Installation And Maintenance Manual page 109

Visual Sianals
LAMP STATUS
LAMP
Line free
Off
Steady glow Line busy
[LINE]
Line on hold
Slow flash
Medium flash Line ringing
Rapid flash Conference in progress
Intercom link free
Intercom Off
Steady glow Intercom link busy
(located in the
[HOLD] key) Slow flash Incoming intercom call
Do Not Disturb activated
Steady glow
Steady glow On-hook dialling activated
Handset Mode off
Off
Steady glow Headset Mode activated
Audible Signals
SIGNAL
Continuous short ring
Short beep followed by voice
Two long beeps
Double chime
Two short bursts of ring repeated at 90 seconds
intervals
Page f- 4
MEANING
MEANING
Intercom voice call
All-station page
Door Station call
Hold recall
Service Tone
Continuous short tone
Slow repeating tone
Long repeating tone
Access Barring
During installation each station will be allocated one of two modes of call
barring:
Unrestricted mode
l
Restricted mode
l
Numbers dialled are compared to an exception table. If a match is found
the call is allowed.
This table consists of two areas:
A programmable area consisting of eight entries of four
digits each, and;
A non-programmable area with fixed emergency numbers, etc.
Commander El O WOEt System User Guide
Know Your Commander
Intercom ring
Busy
I
Page 7-5