Model
Video Input
ZN-S100AE
ZN-S1000AE
ZN-S2000AE
Vin1, Vin2
ZN-S4000AE
Vin1, Vin2,
Termination Resistor DIP Switch may be applied, when Video Input BNC Connector is
used for video loop-out.
T-BNC connector is not included in GANZ encoder package.
⑤ Termination Resistor DIP Switch (75Ω ON)
A switch to turn ON/OFF a 75Ω termination resistor is provided for each video input. Factory default
setting is ON. If impedance is mismatched between video inputs and outputs that are connected
together, you need to turn this DIP switch on/off to match the impedance to 75Ω.
⑥ Video Output BNC Connector (Vout - Only ZN-S4000AE)
Vout is used for ZN-S4000AE to display quad, switching view in external monitor.
⑦ Reset Switch (Reset)
Reset switch is used for restarting GANZ encoder or resetting GANZ encoder as Factory Default
(FD). Refer to '4.1. Factory Default Settings' for detailed procedures.
2010/2-1 O
Single Stream
Video Loop-out
Vin1
-
Vin1
Video Loop-out
T-BNC Connector
T-BNC Connector
Vin4
Table 3. Video Connector Usage
GANZ MPEG-4 Encoder Series Hardware Manual
Video Input
-
-
Vin1
Vin1, Vin3
Dual Stream
Video Loop-out
-
-
Vin2
Vin2, Vin4
7