Functions; Front Panel - Ganz ZN-S100AE Hardware Manual

2.2. Functions

2.2.1. Front Panel

①, ② Indicator LED (Status, Network)
Status (Orange) and Network (Green) indicators display the following system information:
Power OFF
Booting in progress
Successful network connection
Failed network connection
Data transmission in progress
Table 2. Status of the GANZ encoder series indicator LED
1. System initialization and booting
When power is supplied to ZN-S4000AE, it is initialized for approximately 1 second. During this
time, the orange Status LED is turned on. After completion of booting, for a successful network
connection, the green Network LED blinks indicating that data is being transmitted. If network
connection fails, please check the LAN cable is connected or restart GANZ encoder.
2. Video streaming service
When an application runs, the Status LED blinks each second. The Network LED blinks at a rate
proportional to the amount of data being transmitted.
③, ④, ⑧ Video Input BNC Connector (Vin 1, Vin 2, Vin 3 and Vin 4)
It is mainly used for video inputs, however it can be used for video loop-out some case as following
Table 3.
2010/2-1 O
GANZ MPEG-4 Encoder Series Hardware Manual
Figure 1. Front Panel of ZN-S4000AE
Status (Orange)
OFF
ON
ON
ON
Blinking(Slow)
Network (Green)
OFF
OFF
Blinking
OFF
Blinking (Fast)
6