Getting Started; Handheld Device (Hhd) - Schlage CO-250 CORE SERIES User Manual

CO-250 Offl ine Lock User Guide
Follow these steps when setting up a new lock.
1. Install the lock. See the installation guide that came with the lock, or visit
www.schlage.com/support, for more information.
2. Make sure the batteries are installed properly. See Batteries on page 7 for more information.
3. Confi gure the Master Construction Credential (where applicable). See Construction Access Mode
on page 5 for more information. The lock should remain in Construction Access Mode until you are
ready to set up the rest of the system.
4. Test the lock for proper mechanical and electronic operation. See Testing on page 6 for more
information.
5. Consult the Schlage Utility Software (SUS) User Guide for information about confi guring the lock.
6. Familiarize yourself with the information contained in this user guide.
!
Save this user guide for future reference.
!
The Handheld Device is used for programming and setup only.
The Handheld Device (HHD) is used to confi gure locks. The HHD confi gures lock functions that
cannot be confi gured with manual programming, and is used to transfer data fi les between the
access control software and locks.
For more information about the HHD, see the Schlage Utility Software (SUS) User Guide.

GETTING STARTED

HANDHELD DEVICE (HHD)

4