Getting Started; Handheld Device (Hhd); Optional Inside Push Button (Ipb); User Management - Schlage AD-300 Instructions Manual

AD-300 Networked Hardwired Lock User Guide
Follow these steps when setting up a new lock.
1. Install the lock. See the installation guide that came with the lock, or visit
www.schlage.com/support, for more information.
2. Make sure the power is properly connected.
3. Configure the Master Construction Credential (where applicable). See Construction Access Mode
on page 5 for more information. The lock should remain in Construction Access Mode until you are
ready to set up the rest of the system.
4. Test the lock for proper mechanical and electronic operation. See Testing on page 8 for more
information.
5. Connect the lock to the Access Control Panel (ACP). See Connecting to an Access Control Panel
on page 6 for more information.
6. Consult the Schlage Utility Software User Guide for information about configuring the lock.
7. Familiarize yourself with the information contained in this user guide.
!
Save this user guide for future reference.
!
The Handheld Device is used for programming and setup only.
The Handheld Device (HHD) is used to configure locks. This includes transferring data files between
the access control software and locks. For information about the HHD, see the Schlage Utility
Software User Guide.

OPTIONAL INSIDE PUSH BUTTON (IPB)

• The IPB state is communicated to the control panel through the RS-485 connection. The manner
in which the network access control software utilizes this communication is configured at the
host. The IPB may be used to communicate a lock/unlock request or be completely ignored by
the network software. Activity may only be reported to control systems connected by a RS-485
connection.
• The IPB may be configured by the ACP or HHD to take direct action on the lock state in case
communications from the control system to the AD-300 fail and the lock remains powered.
User management is controlled by the access control system. If the access control panel has not yet
been connected, use construction mode to add and delete users.
ÎSee Construction Access Mode on page 5 for more information.

GETTING STARTED

HANDHELD DEVICE (HHD)

USER MANAGEMENT

4