Getting Started - Schlage AD-250 User Manual

Outside
Schlage Button
Outside Lever
Keyway
Inside
Inside Push Button (IPB)
(Optional)
Thumbturn
Inside Lever
Battery Compartment
Follow these steps when setting up a new lock.
1. Install the lock. See the installation guide that came with the lock, or visit
www.schlage.com/support, for more information.
2. Make sure the batteries are installed properly. See Batteries on page 7 for more information.
3. Configure the Master Construction Credential (where applicable). See Construction Access Mode
on page 5 for more information. The lock should remain in Construction Access Mode until you are
ready to set up the rest of the system.
4. Test the lock for proper mechanical and electronic operation. See Testing on page 4 for more
information.
5. Consult the Schlage Utility Software User Guide for information about configuring the lock.
6. Familiarize yourself with the information contained in this user guide.
!
Save this user guide for future reference.
Mag Card
Reader
AD-250-CY
AD-250-MS

GETTING STARTED

3
AD-250 Offline Lock User Guide
Mag Card + Keypad
AD-250-MD
Reader
AD-250-993