Cassette Encoding - boytone BT-19DJB Operating Instructions Manual

7. To stop playback, press the EJECT/FAST FORWARD button completely. Playback will
be stopped and the cassette tape will be ejected.
IMPORTANT!
When using the cassette deck:
 Make sure to insert the cassette in the correct direction.
 To avoid damaging the cassette, we strongly recommend taking it out
of the equipment after playing the cassette.

Cassette encoding

1. Set the function button to TAPE/AUX mode and then insert a memory device (USB
drive, SD or MMC card).
2. Press the record
then the USB or SD icon will be flashing on the LC display.
3. Press the skip up
or SD) for encoding, then press the record
(You can skip this step if only a USB drive or an SD/MMC card is inserted.)
4. The system will start the encoding mode after a few seconds. Insert your cassette into
the playback slot. During encoding, the USB or SD icon will be flashing on the display.
5. To finish encoding, press the stop
to TAPE/AUX mode.
NOTE:
 The recording format is preset at MP3 bit rate 128 kbps.
 The recording speed is 1:1. Recording will take as long as playing the record.
REC button, it will take 3 - 4 second to read the memory device,
or skip down button to select the desired mode (USB
REC button again to confirm.
button. The display will show "END" and return
9